If you are thinking about selling your home or if you have plans to develop a backyard, then it is possible that you might need a Dead Tree Spade. A Dead tree spade is a special type of saw that has a blade that does not break off. If you have a dead tree that you would like to make into a live tree, this article will give you information on how to do that.
To begin, you have to first remove the dead and decaying parts of the tree. The most obvious way to do that is to cut it with a chain saw, but some people also choose to use a tree surgeon saw, or even a straight edge saw. However, if you have time, the best method is to chop the whole tree with a dead-whacking tree spade. You should wear safety equipment, such as gloves and eye protection, and you should only use the power of a tree spade on live trees.
Once the dead tree has been removed, you should also remove any dead or decayed portions of the tree's bark or foliage. You can do this by either removing it from the tree itself, or by removing the entire thing from the ground. Then you should put it in a clean bucket or sack in order to prevent it from getting contaminated while still in its new location. You should also clean any tools or other equipment before you store it away.
After you have cleaned the tree, you should also spade the area, making sure that the root ball is completely covered and that the tree has been completely ground down. The easiest way to do this is to place the spade at least twelve inches from the tree, and to dig a hole that is two feet deep and wide. In this way, the tree will be buried completely, which should lead to better root growth.
Once the ground is prepared, you can begin to remove the dead tree from the ground. You can do this by either using a tree spade, or by hand. However, if you are not experienced at removing dead trees, you should probably opt for the tree spade, as it is easier to work with. Once the dead tree is removed, you should remove the stump from the ground as well.
After the tree is dead, you should place it in a pile somewhere where it will remain dry. If the tree is wet, you should place it in an open area until it dries out. Once it has died, you can begin to use your tree spade to cut off the dead limbs. However, before you start cutting off any parts of the tree, you should make sure that you have first wrapped the tree in burlap or some other type of plastic in order to protect it from the elements. Just make sure that you remember to remove the wrapping once you have finished working with the dead tree.